This is a table clamp designed to stabilize your Worksharp Precision Adjust while you work.
Usage Instructions:
Secure clamp to table. Snug, no need to over torque it.
Loosen small thumb screws and slide in the Worksharp.
Tighten the two small thumb screws closest to you first. Snug.
Tighten the rear two small thumb screws. These only need to touch against the Worksharp base and do not require to be tight. Over tightening these rear screws will cause the clamp to shift.
Remove clamp from tension when not in use.
Works great with my Worksharp clamp arm brace and other accessories. Made from PLA. This material was chosen due to its high stiffness. *Do not store with clamp under tension. Loosen bolts when not in use. I choose PLA plastic because it is one of the stiffest FMD materials. However, if left under tension for a long period of time the plastic can "creep." This means that the plastic stretches from its original position slightly. To avoid this, loosen bolts when not using.*
The Worksharp unit seen in these photos is not included with the clamp. It is seen here for demonstration purposes only.
